Installation - Harmony Youth Booster Manual De Instrucciones

DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place booster seat firmly against the back of a
forward-facing vehicle seat. The vehicle seat MUST
be equipped with a 3-point lap-and-shoulder belt.
Booster must be level, stable and not rock side-to-
side (see "Vehicle seating positions").
2. Place child on the booster seat with child's back flat
against the vehicle seat.
3. Thread both sides of the lap belt
under BOTH armrests.
Thread the lower end
of the shoulder belt
under the armrest on
the buckle side ❶.
ENSURE that the belt
is snug across the child's hips. It is
important to ensure that any lap
strap is worn low down, so that
the pelvis is firmly engaged, just
touching their thighs and is NOT across their stomach.
4. Buckle vehicle seat belt into place. Ensure the buckle
is secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.

INSTALLATION

WARNING!
!
❶
18