Installation - Harmony HMYFLDHBB-S3 Manual De Instrucciones

DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place booster seat firmly against the back of a
forward-facing vehicle seat. The vehicle seat MUST
be equipped with a 3-point lap-and-shoulder belt.
Booster must be level, stable and not rock side-to-
side (see "Vehicle seating positions").
2. Place child in the booster seat with child's back flat
against the back of the booster seat.
3. Adjust headrest height so that the bottom of the
headrest is EVEN with the top of the child's shoulders.
4. Thread shoulder belt portion of
the 3-point
belt system through the shoulder
belt guide ❶ and ensure that
shoulder belt lies across child's
shoulder and chest, and NOT
across child's face or neck.
5. Thread both sides of the lap belt and the lower end
of the shoulder belt of the 3-point lap-and-shoulder
belt system UNDER BOTH booster seat armrests ❷,
and ensure that the belt is snug across child's hips just
touching their thighs and is NOT across their stomach.
6. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
23

INSTALLATION

WARNING!
!
lap-and-shoulder
❶
❷