Function
• This model is designed for operation with H0 2-rail DC sys-
tems (track according to NEM standards) with conventional
DC power packs (12 volts).
• This locomotive is equipped with an electrical interface
connection for digital operation and can be retrofitted with
the 66849 Selectrix locomotive decoder.
• Headlights change over with the direction of travel.
• The special motor and gear train are maintenance free.
• A smoke generator can be retrofitted to the locomotive - also
for analog operation.
The necessary maintenance that will come due with normal
operation is described below. Please see your authorized TRIX
dealer for repairs or spare parts.
Safety Information
• This locomotive is only to be used with the operating system
it is designed for.
• This locomotive must not be supplied with power simultane-
ously by more than one power source.
• Please make note of the safety information in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference with
radio and television reception, when the locomotive is to be run
in conventional operation. The 611 655 interference suppression
set is to be used for thispurpose. The interference suppression
set is not suitable for digital operation.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
WARNING! This product contains magnets. Swallowing more
than one magnet may cause death in certain circumstances.
If necessary, see a doctor immediately.
5