Ignition | Battery Powered; Troubleshooting - Blackstone PRO Serie El Manual Del Propietario

Model 1820 | Owner's Manual |

Ignition | Battery Powered

IGNITION |
!
WA R N I N G
BAT TERY POWERED
Do not lean over griddle
while lighting.
GRIDDLE OPERATING INSTRUCTIONS
For proper ignition and operation of the griddle follow the steps below.
!
WA R N I N G
If ignition does NOT occur in 5
seconds, turn burner controls
OFF, wait 5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner and could
accidentally/inadvertently ignite
with risk of injury.
26
S T E P 0 1
In order for the
igniter switch to work prop-
erly, please make sure battery is
correctly installed.
S T E P 0 2
Turn OFF gas burner
control knobs.
S T E P 0 3
Turn gas ON at LP
cylinder by taking 20 seconds to
turn knob halfway.
S T E P 0 4
To ignite, push and turn
IGNITION BURNER knob to MAX.
S T E P 0 5
Push and hold
ELECTRONIC IGNITION button
until IGNITION BURNER lights.
S T E P 0 6
To ignite remaining
burners, turn each burner knob
in sequence to MAX position.
Start with burner closest to
IGNITION NEEDLE.

TROUBLESHOOTING

Section 01
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignition button does not result in a clicking sound
To determine the cause, please try to ignite your griddle with a match.
(Please reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
01. Dead battery or no battery. Replace with new battery.
02. Battery installed incorrectly. Ensure that the battery is installed nega-
tive end first.
03. Igniter wire misaligned. Ensure that the igniter wire is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
04. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
05. Burner tubes are not Please reference the Gas Flow section of
receiving propane. the Troubleshooting Chapter.
Troubleshooting | Owner's Manual | Model 1820
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
27