Model 1820 | Owner's Manual |
Assembly Guide
S T E P 0 8
bolts and four (4) washers from the inside of the hood and two (2) mica sheets
from the top. Connect the 20lb propane tank (not included). (Please reference
the Connection & Removal section of the Fuel | Propane – 20lb. Tank chapter.)
S T E P 0 9 Proceed to the Griddle Seasoning Instructions section of the
Care & Maintenance chapter.
Pro Series Griddle Cooking Station!
10
Attach the handle on to the griddle hood with four (4) M6X20
Enjoy cooking outdoors on your Blackstone 36"
Section 01
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
CLEANING THE GRIDDLE COOKING SURFACE
02. Pressing the ignition button does not result in a clicking sound
To determine the cause, please try to ignite your griddle with a match.
S T E P 0 1
(Please reference the Match Lighting Instructions in the Cleaning the Burner
each use, cool griddle below 300° F.
Assembly section of the Care & Maintenance chapter.)
Scrape food debris with spatula or
straight metal scraper.
If you CAN ignite your griddle with a match
S T E P 0 2
POSSIBLE CAUSES
SOLUTION
surface with paper towel.
01. Dead battery or no battery.
Replace with new battery.
02. Battery installed incorrectly.
Ensure that the battery is installed nega-
tive end first.
03. Igniter wire misaligned.
Ensure that the igniter wire is posi-
S T E P 0 3
tioned 1/8" to 1/4" away from the burner
into approximately 6" sections
tube, positioned above a burner hole.
(width of scraper tool). Apply a
small amount of water onto first
04. Damage to the ignition system.
Contact customer service for replace-
section with a bottle and then
ment parts.
scrape the water and debris toward
the grease trap. Move to the next 6"
If you CAN NOT ignite your griddle with a match
section and repeat.
POSSIBLE CAUSES
SOLUTION
DO NOT USE MORE THAN TWO
05. Burner tubes are not
Please reference the Gas Flow section of
TABLESPOONS OF WATER
receiving propane.
the Troubleshooting Chapter.
AT A TIME.
1/4 cup of table salt may be used to
buff off stuck food residue.
S T E P 0 4
paper towel and dry completely.
S T E P 0 5
cooking oil to maintain seasoning
and protect the griddle top.
Care & Maintenance
Assembly Guide
| Owner's Manual | Model 1820
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A HOT
To clean griddle after
GRIDDLE AT ONCE. This
may cause warping.
!
C A U T I O N
Wipe down griddle
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy the
griddle's seasoning.
Divide griddle surface
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
Wipe again with a
NEED HELP? Register your Blackstone
product at blackstoneproducts.com/
register-griddle and contact Blackstone
Customer Service for missing parts,
assembly and operation questions:
PHONE:
Apply thin coat of
435-252-3030 ext 1
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/
customer-support
11