Ryobi TSS103 Manual Del Operador página 11

FEATURES
MITER LOCK HANDLE
PADLOCK
See Figure 3.
HOLE
SWITCH
The miter lock handle securely locks the saw at desired miter
SPINDLE
TRIGGER
angles. Tighten the handle to lock the saw in place. To release
LOCK BUTTON
the saw, loosen the handle and squeeze the detent release lever.
MITER SCALE
The miter scale has index points provided at 0°, 15°, 22.5°,
30, 31.6°, and 45°.
PARTIAL SLIDING FENCE
The partial sliding fence on your compound miter saw has
been provided to help secure the workpiece when making
straight cuts.
The sliding feature makes it easy to adjust the position of the
partial fence. Loosen the fence screw before attempting to
slide the partial fence. Once the desired position is determined,
tighten the fence screw to secure.
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 15°, 22.5°, 31.6°, and
45° on both the left and right side of the miter table.
NOTE: To bypass the positive stops, squeeze the detent
release lever and lift the detent override. To release the over-
ride, squeeze the detent release lever.
SWITCH
PADLOCK
TRIGGER
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of shock-resistant, see-through
plastic that provides protection from each side of the blade.
It retracts over the upper blade guard as the saw is lowered
into the workpiece.
SLIDE BARS
When unlocked, the saw arm will glide forward and backward
the length of the slide bars for cutting various workpiece widths.
SLIDE LOCK KNOB
The slide lock knob locks and unlocks the sliding feature of
this tool.
SPINDLE LOCK BUTTON
See Figure 4.
The spindle lock button locks the spindle and stops the blade
from rotating. Depress and hold the lock button while install-
ing, changing, or removing blade.
Fig. 4
SWITCH TRIGGER
See Figure 4.
The saw will not start until you depress the trigger lockout
lever and squeeze the switch trigger. To prevent unauthor-
ized use of the compound miter saw, disconnect it from the
power supply and lock the switch in the OFF position. To lock
the switch, install a padlock (not included) through the hole
in the switch trigger and make certain the switch is inoper-
able. If the switch is still operable with the padlock installed,
a padlock with a larger shackle diameter must be used. Store
the padlock key in another location.
11 − English