Ryobi TSS103 Manual Del Operador página 30

NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figure 38 - 39.
NOTE: This method of cut is for crown molding between
4-5/8 in. and 5-1/4 in. tall. Do not attempt to cut molding
that is larger than 5-1/4 in. tall.
NOTE: It may be necessary to adjust the partial sliding fence
to ensure proper clearance prior to making the cut.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
 Nest and secure the crown molding against miter fence
using a spring clamp and hold crown molding securely.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several sec-
onds for the blade to reach maximum speed.
 Slowly lower the blade into and through the crown
molding.
OPERATION
SPRING
CLAMP
30 − English
SPRING
CLAMP
BOTTOM EDGE
AGAINST FENCE
Fig. 38
CROWN
MOLDING
Fig. 39