VWR VisiScope 400 Serie Manual De Instrucciones página 7

Installing the stage insert
1. When using the glass stage, make sure
that the insert is horizontal.
2. Install the stage insert in the stage
opening. (Fig.6)
Installing the eyepieces
Insert both eyepieces into the tubes of the
optical head. (Fig.7)
Installing the condenser illumination
unit and the LED housing
1. Insert the condenser illumination unit into
the bracket. (Fig.8)
2. Turn the condenser illumination unit
clockwise about 90°, with the "AS" mark
of filter holder facing forwards. Align the
screw of the condenser illumination unit
and the hole of the holder, then screw
the bolt in the hole with the supplied allen
wrench. (Fig.9)
3. Insert the connector plug into the
connector jack.
4. Push the LED housing gently into the
holes of the illumination unit. (Fig.10)
Installing the color filters
► Remove the filter holder, then install the
color filters you need. (Fig.11, Fig.12)
Mount the color filter flat as shown in ①,
verifying that they are not tilted.
► If the color filter is tilted or otherwise
②
out of place , it may fall.
②
The color filters can be stacked in the
holder. This allows to install as many filters
as needed, as long as the whole thickness
is less than 11 mm.
①
7
Fig.8
Fig.6
Fig.7
Fig.9
Fig.10
Fig.11
Fig.12