Flex GE 7 Instrucciones De Funcionamiento Originales página 23

GE 7
 Insert the special dust bag for dry con-
struction dust into your dust extractor
according to the instructions supplied
with the dust extractor.
 Connect extraction hose to the dust
extraction system. Follow the operating
instructions for the dust extraction sys-
tem! Check the attachment!
If required, use an appropriate adapter.
NOTE
If your dust extractor requires a special
connector, the clip-on connection can
be removed and a matching adapter selec-
ted from the FLEX accessories range.
Attaching and changing the sanding
tools
CAUTION!
Before performing any work on the electric
power tool, pull out the mains plug.
 Remove worn sanding tool from
the Velcro pad.
 Place the sanding sheet in the centre
of the Velcro pad and press on.
 Conduct a test run to check that the san-
ding tool is clamped in the centre.
CAUTION!
Never use the Velcro pad as a sanding tool.
Never use the wall sander without the san-
ding sheet, otherwise the work surface will
be seriously damaged!
Switching the electric power tool
on and off
Switch on the machine:
 Press the switch (1.).
 To engage, press the locking button
and release switch (2.).
Switch off the machine:
 Press the switch briefly
Preselecting the speed
To set the operating speed, move the dial
to the required value.
23