Cembre B1300-UC Manual De Uso página 9

2.1) Preparation
The tool can be easily carried using either the main handle (12) or the shoulder strap attached to
the two rings (8).
The main operating positions are: hori-
zontal standing on its feet and vertical
standing on its battery. In addition to
the main handle (12) the lower handle
(6) allows a safer and more balanced grip
when using two hands to hold the tool.
Before starting any work, check
the battery charge (Ref. to § 2.8) and recharge
if necessary, following the instructions in the
battery charger user manual.
To replace the battery, grip the tool as illustrated in Figure;
press the release button (11) and push the battery downward
unlocking it. Insert a charged battery from the bottom by sli-
ding it into the guides until it locks.
The display shows the operational parameters of the tool; to
customise them proceed as described in § 2.7.
Depending on the compression to be performed, proceed as
described in § 4 or 5.
2.2) Die advancement
Press operating button (1) to activate the motor-pump and
advance the lower die.
To halt the advancement, release operating button and the
motor will cut out.
Make sure the dies are exactly positioned on the desired
crimp point otherwise re-open dies following instruc-
tions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (1) pressed, the motor continues
to operate: the ram will gradually move forward until the two
dies touch.
The motor will stop automatically when the set pressure has
been reached.
To perform proper compression, press and hold the operating button (1) until the motor
stops automatically.
9
8
12
8
Battery
1
6
11