Return To Cembre For Overhaul - Cembre B1300-UC Manual De Uso

7.4) ERRORS:
these appear during operation, combined with a beep and fl ashing LED Worklights,
to notify the operator of procedural or operational errors.
Message Error description
The pressure release button (2) was
ERROR
pressed before the control parameters
were reached (Force/Pressure).
Interruption of the signal from the NTC
NTC
temperature probe of the battery.
FAULT
Abnormal power consumption of the
motor for more than 3 seconds.
001
The tool stops.
Output voltage of the pressure transmit-
002
ter is out of the pre-set range.
Failure to reach the set pressure within
003 30 seconds of continuous operation of
the machine.
Overcharging of the battery with pro-
tection tripping.
004
The tool stops.
Errors are displayed for about 30 seconds before being reset, but will display repeatedly in
the event of permanent anomalies.
8. CONNECTION TO COMPUTER (Smartool technology)
The memory card integrated in the tool records operating data for transfer via the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area, then
download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will optimise
the tool's performance.

9. RETURN TO Cembre FOR OVERHAUL

In the case of a breakdown contact our Area Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Test Certifi cate supplied by Cembre together with the tool or fi ll in and attach
the form available in the "ASSISTANCE" section of the Cembre website.
Solution
Repeat the work cycle and wait for the motor
to stop automatically.
Replace the battery.
If the problem persists, please contact Cem-
bre.
Wait for the display to turn off (60 sec.) or
remove and re-insert the battery, then re-
start the tool.
If the error occurs frequently, contact Cembre.
Repeat the work cycle; if the errors reoccurs
frequently, contact Cembre.
Repeat the work cycle; if the errors reoccurs
frequently, contact Cembre.
Wait for the display to turn off (60 sec.) or
remove and re-insert the battery, then re-
start the tool.
If the error occurs frequently, contact Cembre.
16