Aventics DDL Instrucciones De Servicio página 70

70 AVENTICS | DDL | R412009417–BDL–001–AD
Commissioning and Operation
1)
Examples Subbases used
Example 1 Subbases for double solenoid valves
Example 2 Subbases for double solenoid valves
Example 3 Subbases for double solenoid valves
Example 4 Subbases for single solenoid valves
Example 5 Subbases for double solenoid valves
Combined with
Subbases for single solenoid valves
Example 6 Subbases for double solenoid valves
Combined with
Subbases for single solenoid valves
1)
Other combinations may be selected in accordance with your requirements.
How to assign the valve supply:
1. Open the screw cap B (see figure on page 63).
2. Using the S1.1 to S1.5 sliding switches, assign one of the two
supply voltages U
on page 68 and Tab. 13).
There are examples for the assignment of the S1.1 to S 1.5
sliding switches and supply of assembled valves for 32 valve
solenoids in Tab. 15 and Tab. 16 on pages 71, 72 (examples 1
to 6). The following example combinations are listed there:
From an electrical connection viewpoint, the subbases for
double solenoid valves must come first and then those for
single solenoid valves. The maximum number of solenoids
for all the subbases is 32.
or U to each valve group (see Figure
Q1 Q2
Valve equipment
Double solenoid valves
Single solenoid valves
Single and double solenoid valves
Single solenoid valves
Double solenoid valves
Single solenoid valves
Single and double solenoid valves
Single solenoid valves