Installation - Electrolux EN3350MOX Manual De Instrucciones

10 www.electrolux.com
Problem
Side panels of the appli‐
ance are warm.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easi‐
ly.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
6.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.

7. INSTALLATION

WARNING!
Refer to Safety chapters.
7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
Possible cause
The food products tem‐
perature is too high.
Many food products were
stored at the same time.
The FastFreeze function
is switched on.
This is a normal state
caused by operation of
the heat exchanger.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not
wrapped.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
Solution
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FastFreeze func‐
tion".
Make sure that there is at
least 30 mm of space be‐
tween each side of the appli‐
ance and the surrounding
furniture when the ambient
temperature exceeds 38°C.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of the
door.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C