Ryobi RTS08T Manual Del Operador página 34

MAKING A MITER CUT
See Figure 43.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.
 Remove the rip fence.
 Set the blade to the correct depth for the workpiece.
 Set the miter gauge to the desired angle and tighten the
lock knob.
 Make sure the workpiece is clear of the blade before
turning on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
 Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
MAKING A BEVEL CROSS CUT
See Figures 44 - 45.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.
 Remove the rip fence.
 Unlock the bevel locking lever.
 Adjust the bevel angle to the desired setting.
 Lock the bevel locking lever.
 Set the blade to the correct depth for the workpiece.
 Set the miter gauge to 0° and tighten the lock knob.
 Make sure the workpiece is clear of the blade before
turning on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
 Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
 When the cut is made, turn the saw off. Wait for the blade
to come to a complete stop before removing the workpiece.
OPERATION
STRAIGHT
VIEWED FROM THE FRONT, BELOW THE TABLE SAW
TO LOOSEN
TO
TIGHTEN
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
34 - English
MITER CUT
BLADE
LOCKING LEVER
BEVEL CROSS CUT
BLADE
ANGLED
MITER GAUGE
ANGLED
Fig. 43
BEVEL
Fig. 44
MITER GAUGE
STRAIGHT
Fig. 45