Replacement Parts - Pentair OMNIFILTER BF36C Instrucciones De Instalación

Sistema de filtración de agua pesada
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BF36C PERFORMANCE DATA
Important Notice: Read performance data and compare the
capabilities of this system with your actual water treatment
requirements. It is recommended that the supply water be tested,
before installing a water treatment system, to determine your
water treatment needs.
BF36C System with TO8 Filter Cartridge installed
This system has been tested according to NSF/ANSI 42 for
reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to
a concentration less than or equal to the permissible limit for water
exiting the system, as specified in NSF/ANSI 42.
Influent
Substance
Challenge
Concentration
Standard 42
Chlorine
2.0 mg/L ± 10%
Test Conditions
Flow Rate
4.0 gpm
Filter Capacity
40,000 gallons
Inlet Pressure
= 60 psi (4.1 bar)
pH
= 7.5±1
Temperature
= 68°F ± 5°F (20°C ± 2.5°C)
Testing was performed under standard laboratory conditions;
actual performance may vary.
Operating Requirements
Pressure
= 30-100 psi
Temperature
= 40-100°F
Turbidity
= 5 NTU Max.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may be
used on disinfected waters that may contain filterable cysts.
Note: Filter must be maintained according to manufacturer' s
recommendations, including replacement of filter cartridges.
The contaminants or other substances reduced by this water
treatment device are not necessarily in your water.
Cartridge
Media
Micron Size (nominal)
Reduces Sediment
Reduces Chlorine Taste & Odor
30,000 gals or
Filter Capacity**
Recommended Flow Rate
Well Water Use
*Not Tested or Certified by NSF with the exception of the TO8 cartridge.
Based on third party testing.
Maximum
Reduction
Average
Permissible
Requirements
Reduction
Product Water
n/a
≥50%
OMNIFILTER REPLACEMENT CARTRIDGE SELECTION GUIDE
RS6*
RS15*
Pleated
Pleated
String Wound
30
5
Yes
Yes
15,000 gals or
3,000 gals or
6 months
3 months
10 gpm
10 gpm
Yes
No

REPLACEMENT PARTS

Part Number
1
150645
2
OK7
3
153240
4
OW50
5
TO8
6
BF35MB
For replacement parts, contact your nearest OMNIFILTER retailer
or call 800-279-9404.
86.8%
RS22*
RS16*
RS18*
Polyspun
Polyspun
5
1
Yes
Yes
30,000 gals or
30,000 gals or
1 month
6 months
6 months
10 gpm
6 gpm
10 gpm
No
Yes
Nominal rating: Smaller micron rating equals finer filtration.
**Filter capacity is approximate and varies depending on conditions.
Description
1-inch Valve-in-Head Cap
O-Ring
Clear Housing
Wrench
Replacement Cartridge
Mounting Bracket
1
2
3
TO6*
TO8
Pleated
Radial Flow
Carbon Wrap
Carbon
50
5
25
Yes
Yes
Yes
Yes
Yes
15,000 gals or
40,000 gals
3 months
5 gpm
4 gpm
Yes
No
Yes
CB6*
Carbon Block
1
Yes
Yes
15,000 gals or
3 months
5 gpm
Yes
• 5 •

Publicidad

Tabla de contenido
loading

Tabla de contenido