Programming Worksheets; System Options; Programming Options; Ethernet Receiver 1 Options - DSC TL260GS Manual De Instrucciones

System Options

[001] Ethernet IP Address
Default (0.0.0.0); Each 3-digit segment of the IP address must be
within a valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[002] Ethernet IP Subnet Mask
Default (255.255.255.000); Each 3-digit segment of the address must
be within a valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[003] Ethernet Gateway IP Address
Default (0.0.0.0); Each 3-digit segment of the address must be within a
valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[004] Heartbeat Interval
Default (0087) 135 seconds; Valid entries range from 0000 to FFFF
seconds.
|____|____|____|____|
[005] System Toggle Options
|____|
[1] Ethernet Receiver 1 Supervised
|____|
[2] GPRS Receiver 1 Supervised
|____|
[3] Supervision Type
|____|
[4] Primary Comms Channe
TL265GS, ON - GS2060/GS2065)
|____|
[5] Redundant Communications
|____|
[6] Remote Firmware Upgrade
|____|
[7] Reserved
|____|
[8] Reserved

Programming Options

[011] Installer Code
Default (CAFE); Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|
[012] DLS Incoming Local Port
Default (0BF6 / 3062); Valid entries range from 0000 to FFFF hexadeci-
mal.
|____|____|____|____|
[013] DLS Outgoing Local Port
Default (0BF8 / 3066); Valid entries range from 0000 to FFFF hexadeci-
mal.
|____|____|____|____|
[021] System Account code
Default (FFFFFF); Valid entries range from 000001 to FFFFFE.
|____|____|____|____|____|____|
[023] Panel Absent Trouble
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|
[024] Panel Absent Trouble Restore
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|
[026] Ethernet 1 Test Transmission
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|
[028] GPRS 1 Test Transmission
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|
[029] GPRS 2 Test Transmission
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|

PROGRAMMING WORKSHEETS

Default (OFF)
Default (OFF)
Default (OFF)
Default (OFF - TL260GS
Default (OFF)
Default (ON)
Default (OFF)
Default (OFF)
[030] FTC Restore
Default (FF); Program 00 to disable this event transmission or FF to
enable.
|____|____|

Ethernet Receiver 1 Options

[101] Ethernet Receiver 1 Account Code
Default (0000000000); Valid entries range from 0000000001 to
FFFFFFFFFE hexadecimal.
|____|____|____|____|____|____|____|____|____|____|
[102] Ethernet Receiver 1 DNIS
Valid entries range from 000000 to FFFFFF hexadecimal.
|____|____|____|____|____|____|
[103] Ethernet Receiver 1 IP Address
Default (127.0.0.1); Each 3-digit segment of the address must be
within a valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[104] Ethernet Receiver 1 Remote Port
Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|
[105] Ethernet Receiver 1 Local Port
Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|

Ethernet Receiver 2 Options

[111] Ethernet Receiver 2 Account Code
Default (0000000000); Valid entries range from 0000000001 to
FFFFFFFFFE hexadecimal.
|____|____|____|____|____|____|____|____|____|____|
[112] Ethernet Receiver 2 DNIS
Valid entries range from 000000 to 0FFFFF hexadecimal.
|____|____|____|____|____|____|
[113] Ethernet Receiver 2 IP Address
Default (0.0.0.0); Each 3-digit segment of the address must be within a
valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[114] Ethernet Receiver 2 Remote Port
Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|
[115] Ethernet Receiver 2 Local Port
Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|
Ethernet Options
[124] Ethernet Test Transmission Time of Day
Default (9999); Valid entries range from 00 to 23 for the hours (HH) and
00 to 59 for the minutes (MM).
|____|____|____|____|
[125] Ethernet Test Transmission Cycle
Valid entries range from 000000 to 999999 minutes.
|____|____|____|____|____|____|

GPRS Receiver 1 Options

[201] GPRS Receiver 1 Account Code
Default (0000000000); Valid entries will range from 0000000001 to
FFFFFFFFFE hexadecimal.
|____|____|____|____|____|____|____|____|____|____|
[202] GPRS Receiver 1 DNIS
Valid entries range from 000000 to 0FFFFF hexadecimal.
|____|____|____|____|____|____|
[203] GPRS Receiver 1 IP Address
Default (0.0.0.0); Each 3-digit segment of the address must be within a
valid range of 000 to 255.
|____|____|____| |____|____|____| |____|____|____| |____|____|____|
[204] GPRS Receiver 1 Remote Port
Default (3061); Valid entries range from 0000 to FFFF hexadecimal.
|____|____|____|____|
[205] GPRS Receiver 1 APN
___________________________________________
14
Default (000000);
Default (0BF5 / 3061);
Default (0BF4 / 3060);
Default (000000);
Default (0BF5 / 3061);
Default (0BF9 / 3065);
Default (000000);
Default (000000);
Default ( )