Maintenance And Inspection - Metabo HPT GP 10DL Manual De Instrucciones

English

MAINTENANCE AND INSPECTION

CAUTION
Pull out battery before doing any inspection or maintenance.
1. Inspecting the accessories
Using a tip tool or mandrel with a worn or
damaged end will not only result in a poor
fi nish, but will place unreasonable strain on the
motor, causing reduced effi ciency, damage or
injury.
If the tip tool or mandrel is worn or damaged,
replace it.
2. Check the screws
Loose screws
inspect them and make sure they are tight.
CAUTION
Using this power tool with loosened,
screws is extremely dangerous.
3. Check for dust
Dust may be removed with a soft cloth or a
cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or
thinner, for they may damage the plastics.
4. Disposal of the exhausted battery
WARNING
Do not dispose
battery. The battery must explode if it is
incinerated. The product that you have
purchased contains
battery. The battery is recyclable. At
the end of it's useful life, under various
state and local laws, it may be illegal to
dispose of this battery into the municipal
waste stream. Check with your local solid
waste offi cials for details in your area for
recycling options or proper disposal.
20
are dangerous. Regularly
of the exhausted
a rechargeable
5. Storage
Storing in a place below 104°F (40°C) and out
of the reach of children.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been
fully charged before storing them.
Prolonged storage (3 months or more) of
batteries with a low charge may result in
performance deterioration,
reducing battery usage time or rendering the
batteries incapable of holding a charge.
However, signifi cantly reduced battery usage
time may be recovered by repeatedly charging
and using the batteries two to fi ve times.
If the battery usage time is extremely short
despite repeated charging and use, consider
the batteries dead and purchase new batteries.
6. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because
of wear from normal use. To assure that only
authorized replacement parts will be used,
all service and repairs must be performed
by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.
CAUTION
In the operation and maintenance of power
tools, the safety regulations and standards
prescribed in each country must be
observed.
signifi cantly