Important Safety Instructions For Battery Charger - Metabo HPT GP 10DL Manual De Instrucciones

Mini amoladora recta a bateria
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
18. Never push in the push button while the spindle
is running.
19. Always wear eye protection that meets the
requirement of the latest revision
of ANSI Standard Z87.1.
20. Always wear a mank or respirator to protect
yourself from dust or potentially harmful
particles
generated
operation.
21. Always be careful with buried objict such as an
underground wiring.
Touching these active wiring or electric cable
with this tool, you may receive an electric
shock.
Comfi rm if there are any buried object such as
electric cable within the wall, fl oor or ceiling
where you are going to operate here after.
22. Defi nitions for symbols used on this tool
V ............ volts
— --- ......... direct current
Hz .......... hertz
A ............ amperes
n
............ rated speed
---/min ... revolutions or reciprocation per minute
IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY
CHARGER
WARNING
Death or serious bodily injury could result
from improper or unsafe use of battery
chargers. To avoid these risks, follow these
basic safety instructions:
AC input rating ampere*
Equal to or
greater than
0
2
3
8
during
the
grinding
Table 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
READ ALL INSTRUCTIONS
1. This manual contains important safety and
operating instructions for battery charger
models UC10SL2 / UC10SFL.
2. Before
using
battery
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
3. To reduce risk of injury, charge metabo HPT
rechargeable battery type BCL1015. Other type
of batteries may burst causing personal injury
and damage.
4. Use of an attachment not recommended or
sold by the battery charger manufacturer may
result in a risk of fi re, electric shock, or injury to
persons.
5. To reduce risk of damage to electric plug and
cord, pull by plug when disconnecting battery
charger.
6. Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
7. An extension cord should not be used unless
absolutely
necessary.
extension cord could result in a risk of fi re and
electric shock.
If extension cord must be used make sure:
a. That blades of extension cord are the same
number, size, and shape as those of plug on
battery charger:
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough for AC
ampere
rating
specifi ed in Table 1.
AWG size of cord
Length of cord, feet (meter)
25 (7.5)
50 (15)
18
18
18
18
18
18
charger,
read
Use
of
improper
of
battery
charger
100 (30)
150 (45)
18
16
16
14
16
14
all
as

Publicidad

Tabla de contenido
loading

Tabla de contenido