Important Safety Instructions For Use Of The Battery And Battery Charger; Caution On Lithium-Ion Battery - Metabo HPT GP 10DL Manual De Instrucciones

* If the input rating of a battery charger is given
in watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating ―for example:
1,250 watts
125 volts
8. Do not operate battery charger with damaged
cord or plug-replace them immediately.
9. Do not operate battery charger if it has
received a sharp blow, been dropped, or
otherwise damaged in any way; take it to a
qualifi ed serviceman.
10. Do not disassemble battery charger; take it to a
qualifi ed serviceman when service or repair is
required. Incorrect reassembly may result in a
risk of electric shock or fi re.
11. To reduce risk of electric shock, unplug
charger from receptacle before attempting any
maintenance or cleaning. Removing the battery
will not reduce this risk.
IMPORTANT SAFETY
INSTRUCTIONS FOR USE OF
THE BATTERY AND BATTERY
CHARGER
You must charge the battery before you can
use the power tool. Before using the models
UC10SL2 / UC10SFL battery charger, be sure to
read all instructions and cautionary statements on
it, the battery and in this manual.
CAUTION
Use only metabo
BCL1015. Other types of batteries may
burst and cause injury!
Follow these instructions to avoid the risk of injury:
WARNING
Improper use of the battery or battery
charger can lead to serious injury. To avoid
these injuries:
1. Never disassemble the battery.
2. Never incinerate the battery, even if it is
damaged or is completely worn out. The battery
can explode in a fi re.
3. Never short-circuit the battery.
= 10 amperes
HPT battery
4. Never insert any objects into the battery
charger's air vents. Electric shock or damage to
the battery charger may result.
5. Never charge outdoors. Keep the battery away
from direct sunlight and use only where there is
low humidity and good ventilation.
6. Never charge when the temperature is below
32°F (0°C) or above 104°F (40°C).
Charging the battery at temperatures outside
the range of 32°F – 104°F (0°C – 40°C) may
prevent proper charging and reduce battery
life.
7. Never connect two battery chargers together.
8. Never insert foreign objects into the hole for the
battery or the battery charger.
9. Never use
charging.
10. Never use an engine generator or DC power to
charge.
11. Never store the battery or battery charger in
places where the temperature may reach or
exceed 104°F (40°C) such as inside metal box
or car.
12. Never expose the battery or battery charger to
rain or wet conditions.
13. Always operate
household electrical power (120 volts). Using
the charger on any other voltage may overheat
and damage the charger.
14. Always wait at least 15 minutes between
charges to avoid overheating the charger.
15. Always disconnect the power cord from its
receptacle when the charger is not in use.
CAUTION ON LITHIUM-ION
BATTERY
type
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output.
In the cases of 1 to 3 described below, when using
this product, even if you are pulling the switch,
the motor may stop. This is not the trouble but the
result of protection function.
1. When the battery power remaining runs out,
the motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop.
In this case, release the switch of tool and
eliminate causes of overloading. After that, you
can use it again.
a booster transformer
charger on
English
when
standard
9