Using The Controls - Thermador KBUIT4250E Manual De Uso Y Cuidado

IMPORTANT:
The refrigerator control adjusts the refrigerator compartment
temperature. The freezer control adjusts the freezer
compartment temperature.
Wait 24 hours after you turn on the refrigerator before you put
food into it. If you add food before the refrigerator has cooled
completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer controls to a
lower (colder) setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The preset settings should be correct for normal household
usage. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
The actual temperature may differ from the display when a
door is open for an extended period of time.
NOTE: The factory recommended set points are 0°F (-18°C)
for the freezer and 37°F (3°C) for the refrigerator.
Turning Refrigerator On and Viewing Set Points
Press and hold POWER (ON/OFF) for 2 seconds.
Viewing the Celsius Temperatures
Press °C SELECT touch pad. The negative sign (-) will light up.
To redisplay degrees Fahrenheit, press °C SELECT again.
NOTE: If the freezer temperature is below zero, the negative sign
next to the freezer display will light up. This is normal.
Adjusting Controls
NOTE: Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
To adjust set point temperatures:
Press the refrigerator or freezer PLUS (+) or MINUS (-) keypad
until the desired temperature is reached.
NOTE: The set point range for the freezer is -5°F to 6°F (-21°C to -
14°C). The set point range for the refrigerator is 34°F to 46°F (1°C
to 8°C).
CONDITION/REASON:
REFRIGERATOR too cold
Not set correctly for conditions
REFRIGERATOR too warm
High use or room very warm
6

Using the Controls

TEMPERATURE
ADJUSTMENT:
REFRIGERATOR Control
1° higher
REFRIGERATOR Control
1° lower
CONDITION/REASON:
FREEZER too cold
Not set correctly for conditions
FREEZER too warm/too little ice
High use or heavy ice use
Water Filter Status and Reset
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
The water filter display will help you know when it is time to
change your filter. To change the filter, see the "Water Filtration
System" section.
INDICATOR:
99 percent
10 percent
0 percent or flow decreases
After replacing the water filter, press RESET and hold for
2 seconds to change the water filter display to 99 percent.
Holiday Feature
The Holiday feature is designed for the traveler or for those whose
religious observances require turning off the lights and ice maker.
By selecting this feature, the temperature set points remain
unchanged, the ice maker will be disabled and the interior lights
will turn off. For most efficient refrigerator operation, it is
recommended to exit the Holiday feature when it is no longer
required.
Press HOLIDAY to turn on the Holiday feature. This feature will
remain on until the Holiday key is pressed again.
NOTE: If the Max Cool feature has been selected prior to
turning on the Holiday feature, then the set points will remain
at 34°F (1°C) and -5°F (-21°C) for the refrigerator and freezer
compartments, respectively, until the Max Cool feature times
out. The refrigerator will then return to the previous
temperature set points chosen prior to the selection of the
Max Cool feature, but the lights and ice maker will remain off
until the Holiday key is pressed again.
TEMPERATURE
ADJUSTMENT:
FREEZER Control
1° higher
FREEZER Control
1° lower
STATUS:
New filter installed
Order replacement filter
Replace filter