Replacing Sensors; Connecting The Soap Tank - Franke ALIO101 Instrucciones De Montaje Y Uso

15. Replacing Sensors

☞
It is always only possible to replace one sensor!
15.1 Disconnect the power source (siehe
15.2 Remove the defective sensor.
15.3 Install and connect the new sensor.
15.4 Connect the power source (siehe
☞
Important!
Wait at least 2 minutes.
• The system automatically detects the new sensor and logs it on.

16. Connecting the Soap Tank

☞
Before the soap tank can be connected, the sensors must be logged in
(siehe Kapitel
16.1 Replace the soap tank.
16.2 Keep the switch below the soap pump pressed. Allow your hand to approach the sensor
and then hold your hand in front of it until soap flows from the outlet.
☞
The soap pump operates permanently.
8
Kapitel
13.).
Kapitel 13.11).
13.8).