ELICA EAS422SS Guía De Instalación, Uso Y Mantenimiento página 9

Install range hood
I WARNING
EXCESSIVE WEIGHT HAZARD.
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
RANGE HOOD.FAILURE TO DO SO CAN RESULT IN BACK OR
OTHER INJURY.
1
Install the four face panel brackets on the left & right inner
walls of the hood assembly. Use 2 installation screws for
each bracket.
B
A. Face Panel Brackets
2 Using 2 or more people, lift the hood liner into its mounted
location. Attach with four 4.2 x 19 mm screws into the
slotted openings. Do not tighten screws.ç
3
Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19 mm
screws into the hood canopy assembly and tighten all (8)
mounting screws.
A
A. Cabinet
B. Hood liner canopy assembly
4 Remove the metal grease filters from the face panel.
5 Connect the lamps connector to the connector present
inside the hood as shown in drawing.
B
A. Lamp connector
B. Hood connector
A
B
B. Screws - 4.2 x 19 mm (8)
B
C
C. Screws - 4.2 x 19 mm (8)
A
6 Attach the face plate to the plate brackets previously
attached to hood insert. Tighten to secure.
NOTE: If cabinet depth is greater than 12", it is recommended
that the two 1 ⁄ " metal spacers are installed.
2
Install to front and rear sides of the face plate with 3.5 x 9.5 mm
screws as shown in drawing.
Peel of the protective film from the face plate before install it.
C
A
A. Face Panel
B. Front and rear spacer
C
A. Screws - 3.5 x 9.5 mm flat-head (4)
B. Face plate (30" x 12"[76.2 cm x 30.5 cm] shown)
C. Cabinet (30" x 12" [76.2 cm x 30.5 cm] shown)
D. Screws - 4.2 x 15 mm truss-head (2)
Connect the vent system
Vented Installations
1 Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
Non-Vented (recirculating) Installations
1 Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
2 Install charcoal filters.
See the "Available accesories" section.
C
B
C. Screws - 3.5 x 9.5 mm (4)
D
A
B
9