Connecting With A Computer Equipped With An Analog Rgb Connector - Sony SRX-S110 Manual De Instalación E Usuario

Left side
INTER LOCK ETHERNET RS232C
DVI-D connector
DVI cable
(not supplied)
to DVI output
Notes
• According to the input signal type, set "Signal Mode" on
"Input Source" in the PICTURE CONTROL window of
the SRX Controller. (page 23)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
20
Connecting the Projector
DVI-D AUX
AUX connector
Computer
Connecting With a Computer
Equipped With an Analog RGB
Connector
Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a computer.
Left side
INTER LOCK ETHERNET
RS232C
R/G/B/HD/VD
connectors
Computer
Note
Select "RGB" in "Signal Mode" of "Input Source" in the
PICTURE CONTROL window.
For details, see page 23.
DVI-D AUX
R(P /C ) G(Y/Y) B(P /C ) HD VD
r r b b
IN OUT
IN OUT
Monitor cable (not supplied)
to monitor output