Technical Information; Installation Considerations - Hansgrohe Talis C 14315 1 Serie Instrucciones De Montaje

Tabla de contenido

Publicidad

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Flow rate - 14315xx1, 31312xx1
spout
handshower
Flow rate - 14314xx1, 31314xx1
spout
handshower
Flow rate - 14313xx1, 31313xx1
spout
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The four-hole trim sets require rough 06646000
(not included). The three-hole trim sets require
rough 06607000 (not included).
• This unit is not anti-scald. If required by local
plumbing code, install this unit in combination
with an approved remote pressure balance
valve or other approved device.
• The finished mounting surface must be complete
and made watertight before installation of this
trim.
• 14315xx1, 31312xx1 only: T his h andshower
is for use with automatic compensating valves
rated at 1.4 GPM (5.3 L/min) or less.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
5.0 GPM (19 L/min)
max. 1.8 GPM (6.8 L/min)
5.0 GPM (19 L/min)
max. 2.0 GPM (7.6 L/min)
5.8 GPM (22 L/min)
• 14314xx1, 31314xx1 only: T his h andshower
is for use with automatic compensating valves
rated at 1.5 GPM (5.7 L/min) or less.
• Protection against backflow is provided by a
check valve in the handshower elbow and by an
automatically resetting diverter.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve
(not included) must be no higher than
120°F (49°C). In Massachusetts, the maximum
output temperature can be no higher than 112°F
(44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.

Publicidad

Tabla de contenido
loading

Tabla de contenido