Fein FSC 1.6X Instrucciones De Uso página 16

3 41 01 092 21 0.book Seite 16 Mittwoch, 2. Juli 2008 4:10 16
EN
Attaching/replacing the sanding sheet (Figure 8).
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
The attachment for the sanding pad to the
drive shaft is infinitely adjustable. When
carrying out any work using the sanding
pad, it is necessary to use the adapter for
the Multimaster accessories (Fig. 8).
Align the sanding sheet and press it
onto the sanding plate by hand.
Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and pre-
vents premature wear.
The sanding sheet can be pulled off again
and then remounted offset by 120° when
only one tip of the sanding sheet is worn.
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respec-
tive application.
Connecting the dust extraction
(Figure 2, ).
When working materials that
CAUTION
produce dust, the power tool
is to be connected to an external dust extrac-
tion via the extraction adapter.
The vacuum cleaner must be suitable for
the material being worked.
When vacuuming dry dusts that are partic-
ularly hazardous to one's health or carcino-
genic, a specialty vacuum cleaner is to be
used.
16
Fig. 8
Sanding
sheett
Sanding pad
Switching ON and OFF (Figure 1).
First check that the power
WARNING
cable and power plug are
not damaged.
Always hold the power tool
CAUTION
firmly. Otherwise, you
could lose control over the power tool.
Switching ON:
Push the switch towards the
front (I).
Switching OFF:
Push the switch towards the
back (0).
FSC 1.6X / FSC 2.0X