Fein FSC 1.6X Instrucciones De Uso página 17

3 41 01 092 21 0.book Seite 17 Mittwoch, 2. Juli 2008 4:10 16
FSC 1.6X / FSC 2.0X
Setting the oscillating frequency
(Figure 1).
The oscillating frequency can be set infi-
nitely variable with the dial control.
Increasing the oscillating frequency:
Turn dial control in counterclock-
wise direction.
Decreasing the oscillating frequency:
Turn dial control in clockwise direc-
tion.
Securing the work piece.
Secure the workpiece firmly.
CAUTION
A work piece that is gripped
tightly in a clamping device or vice, is more
secure than if held by hand.
Maintenance.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Service
Have maintenance carried
WARNING
out only through qualified
personnel. Incorrectly mounted leads and
components can cause serious injuries. Have
the required service carried out only
through a FEIN customer service agent.
Cleaning
Prior to any cleaning or
WARNING
maintenance, disconnect the
power tool from the power supply in order to
avoid accidents. It is best to clean the power
Sanding
Typical application: Dry sanding of wood and
metal, especially of smaller surfaces, corners
and edges, as well as hard to reach locations.
Work with the complete surface of the sand-
ing plate, not only with the tip. Select a high
oscillating frequency. Sand with continuous
motion and light pressure. Applying excessive
pressure does not increase material removal;
only the sanding sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel
sheet, wood and plastic components.
Select a high oscillating frequency.
Round saw blades can be clamped offset
again to provide uniform wear.
Scraping
Typical application: Scraping off old coats of
varnish or adhesives, removing bonded car-
peting, e. g., on stairs/steps or other small/
medium-sized surfaces.
Select a medium to high oscillating frequency.
tool with dry compressed air. When clean-
ing power tools with compressed air, always
wear safety goggles.
When working metal under
WARNING
extreme operating condi-
tions, it is possible for conductive dust to set-
tle in the interior of the power tool. The total
insulation of the power tool can be impaired.
For such cases, frequent blowing out the
ventilation slots and connecting a ground-
fault circuit interrupter (g.f.c.i.) in series is
recommended.
EN
17