Setting Surface Controls; Sizes Of The Surface Gas Burners - Sears Kenmore 790.3667 Serie Manual De Uso Y Cuidado

Setting Surface Controls

Sizes of the Surface Gas
Burners
Your appliance is supplied with the
following 3 different surface gas
burners:
• Simmer Burner (5,000 BTU)
• 2 Standard Burners (9,500 BTU)
• Power Burner (12,200 BTU)
When setting up the range for
the first time, make sure that
the correct Burner Heads,
Burner Caps and Burner
Grates are located as shown
in Figure 1.
Burner
Grate
Burner
Cap
Cap Pilot
Burner
Head Hole
Electrode
Gas
Opening
Electrode must be
located properly in slot
of each Burner Head
Figure 2
Removable Oven
Vent Covers
Fixed Oven
Vent Cover
Figure 3
Burner Cap
(Standard)
Standard
Burner Head
(9,500 BTU)
Left Front
Gas Opening
"POWER"
Burner Head
(12,200 BTU)
Grate
Pin
Assembly of the Surface Burner Heads, Burner Caps,
Burner Grates and Flue Covers
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly
and at the correct locations.
1. Place all 4 Burner Heads in the correct locations (See Figure 1).
Make sure that the correct Burner Head is placed with the
corresponding Gas opening and that the Electrode is located
properly in the slot of each Burner Head (See Figure 2). Proper
Burner Head placement insures that each Burner will have the
correct spark required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations
(Burner Cap Pilot Hole must face up). Each of the 4 (four) Burner
Heads MUST have a Burner Cap installed to insure proper ignition
and gas flame size and must be in place with the Pilot Hole facing
up BEFORE placing the Burner Grates (See Figure 2).
3. Place the 2 (two) cast iron Burner Grates supplied with the range.
Carefully line-up the 2 Grate Pins on each Grate with the Cap Pilot
Holes in the 2 Burner Caps on each side of the range. DO NOT
force the Burner Grates onto the Burner Caps. Forcing the grates
down onto improperly installed Burner Heads and Burner Caps may
damage the gas burners. Each Burner Cap is designed with a Cap
Pilot Hole in the top center of the Cap. Visually check that ALL the
Grate Pins line up into the Burner Cap Pilot Holes (See Figure 2).
Properly installed Burner Grates will rest with all four Grate legs on
the glass cooktop.
4. Place the 2 (two) removable oven vent covers over the fixed oven
vent cover as shown on figure 3.
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.
9
Burner Cap
(Standard)
Standard
Burner Head
(9,500 BTU)
Left Rear
Gas
Opening
Extra Large
Burner Cap
Right Rear
Gas Opening
Right Front
Gas Opening
Small
Burner Cap
"SIMMER"
Burner Head
(5,000 BTU)
Figure 1