Conversion To Liquified Petroleum Gas (Or L; Setting Surface Controls; Sizes Of The Surface Gas Burners - Sears Kenmore 790.4710 Serie Manual De Uso Y Cuidado

Conversion to Liquefied Petroleum Gas (or L.P. Gas)
This appliance can be used with Natural Gas and Propane Gas. It is shipped from
the factory for use with natural gas.
If you wish to convert your range for use with LP/Propane gas, use the supplied fixed
orifices located in a bag containing the literature marked, "FOR LP/PROPANE GAS
CONVERSION". Follow the instructions packaged with the orifices.
The conversion must be performed by a qualified service technician in accordance
with the installation instructions furnished with this range and all codes and
requirements of the authority having jurisdiction. Failure to follow instructions could
result in serious injury or property damage. The qualified agency performing this
work assumes responsibility for the conversion.

Setting Surface Controls

Sizes of the Surface Gas
Burners
Your appliance is supplied with
the following 4 different surface
gas burners:
• Simmer Burner (5,000 BTU)
• Standard Burner (9,500 BTU)
• Power Burner (12,000 BTU)
• Power Burner (14,200 BTU)
When setting up the range for the
first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Burner Cap
(Standard)
Standard
Burner Head
(9,500 BTU)
Left Front
Orifice Holder
8
death from electrical shock may occur
if the range is not installed by a
qualified installer or electrician.
or conversions required in order for this
appliance to satisfactorily meet the
application needs must be made by an
authorized Sears Service Center.
Large Burner Cap
"POWER"
Burner Head
(12,000 BTU)
Left Rear
Orifice Holder
Extra Large
Burner Cap
"POWER"
Burner Head
(14,200 BTU)
Right Front
Orifice Holder
Personal injury or
Any additions, changes
Small
Burner Cap
"SIMMER"
Burner Head
(5,000 BTU)
Right Rear
Orifice Holder
Figure 1