Yard force YF21-SD-TW Manual Del Operador página 13

ASSEMBLY
SETTING THE CUTTING HEIGHT
As shown in Fig. 11
Fig.11
Low
Medium
High
3.25"(83mm) 1.25"(32mm)
CAUTION! Adjust the cutting height only when the engine is not running.
NOTE: Before operating the mower adjust cutting height to the normal cutting position.
Adjust the cutting height to suit your requirements. The middle position is suitable for most lawns.Raise the
wheels for low cut and lower the wheels for a high cut.
Cutting height adjustment may be made by moving axle bolts and wheels to desired position. Cutting
heights will be raised as axle bolts are moved to a lower hole and lowered as axle bolts are moved to a
higher hole in the deck. All axle bolts must be assembled so that the cupped side of the washers are against
the deck. See Fig. 11
From low position to high position, the cutting heights range from 1.25" to 3.25'' (32 to 83 mm). Be sure all
the wheels are at the same height. NOTE: Use equivalent holes to attach all four wheels.
13
Hotline: 1-866-902-9690