Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 13 Backguard Installaion
Back panel of backguard is positioned behind
the guide channels on the back of the range.
The backguard must be attached before sliding the range into the final installed position. A Low Back or High
Shelf backguard must be installed when there is less than a 12" clearance between combustibles and the
back of the range above the cooking surface. (See Fig. 2A and 2B on Page 6).
An Island Trim is available for covering the backguard mounting flanges for island installations, where there
is a minimum of 12" of horizontal clearance between combustibles and the back of the range. (See Fig.
2B on Page 6).
The backguard is inserted, as shown in Fig. 13, behind the guide channels on the back of the range. Using
the sheet metal screws provided, fasten the backguard to the back of the range.
To avoid possible burn or fire hazard, a backguard designed specifically for this range must be installed
whenever the range is used.
Chart D: Backguard Kit Model Numbers
Range Model No.
DP304
Included with Range
DP36
Step 7: Backguard Installation
WARNING
6" Std. Low Back
N/A
9" Low Back
22" High Shelf
N/A
DFP30HS
DFP36LB
DFP36HS
17
3" Island Trim
DFP30IT
DFP36IT
Publicidad
Capítulos
