MSA 10207314 Instrucciones De Uso página 8

1. Measure the diameter of the tool shaft. Use the tool weight and shaft diameter in the table
above to determine the appropriate tool tether and length of tape piece needed.
US
8
2. Place the handle of the tool on top of the loop on
the loop end of the tether (web end side down).
3. Guide the opposite end of the tether including
the D-ring or side release buckle through the
loop.
4. Pull tight and adjust the slide lock to snugly
secure the loop around the tool.
5. Place the tether along the handle of the tool,
making sure the web end is facing up.
MSA Tool Tethers with Loops