SICK SureSense HL18L Manual De Operación página 50

62 拆卸和废弃处理
63 保养
8017856.YMH6 | SICK
Subject to change without notice
LED 指示灯 / 故障界面 /
LED indicator/fault pattern
Yellow LED flashes; if Health
is present then take note of
the corresponding output
signal; if Alarm is present
then take note of the corre‐
sponding output signal
探测物体时信号中断 /
Signal interruptions when
object is detected
必须根据当地特定的法律法规废弃处理传感器。如果其中含有可回收材料（尤其是
贵金属），则必须在废弃处理时回收利用。
SICK 传感器无需保养。
我们建议，定期：
• 清洁镜头检测面
• 检查螺栓连接和插头连接
不得对设备进行任何改装。
如有更改,不另行通知。所给出的产品特性和技术参数并非质保声明。
原因 /
Cause
additionally with health out‐
put: power supply interrup‐
ted
物体表面的去极化特性（例
如：薄膜），折射 /
Depolarizing property of the
object surface (e.g., tape),
reflection
62
拆卸和废弃处理
措施 /
Measures
器和反射器之间的间距并使
用图 H 检查反射器类型 / 反
射器不适用于所选应用（我
们建议仅使用 SICK 反射
器） / 检查开关距离，必要
时调整；参见图 H. / 传感器
和反射器之间的间距过大 /
Health 输出端：检查电源，
检查整体电气连接（电缆和
插头连接） /
Check the operating condi‐
tions: Fully align the beam
of light (light spot) with the
reflector. / Clean the optical
surfaces (sensor and reflec‐
tor). / Readjust the sensitivi‐
ty (potentiometer) / If the
potentiometer is set to the
max. sensing range: Redu‐
ce the distance between
the sensor and the reflec‐
tor, and check the reflector
type against graphic H. /
Reflector is not suitable for
the application in question
(we recommend only using
SICK reflectors) / Check
sensing range and adjust if
necessary; see graphic H. /
Distance between the sen‐
sor and the reflector is too
long / With health output:
Check the power supply,
check all electrical connec‐
tions (cables and plug con‐
nections).
降低灵敏度或更改传感器位
置 /
Reduce sensitivity or
change the position of the
sensor
49