SICK SureSense HTF18L Instrucciones De Operación página 48

Ocultar thumbs Ver también para SureSense HTF18L:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
69
故障診断
70
表エラー診断
8017859 | SICK
Subject to change without notice
ダークオン
2
1
時間段階は 0~2 秒に設定できます。
ライト / ダーク切替スイッチ: オプションのライト / ダークロータリースイッチが
「L」位置にある場合、センサはライトオンモードです。オプションのライト / ダー
クロータリースイッチが「D」位置にある場合、センサはダークオンモードです。
モードが切り替わると、供給電源の緑色の LED が一回のみ光ります。
表 I は、センサが機能しなくなった場合に、どのような対策を講じるべきかを示し
ています。
LED 表示灯/故障パターン /
LED indicator/fault pattern
緑色の LED が点灯しない /
Green LED does not light up
緑色の LED が点灯しない /
Green LED does not light up
緑色の LED が点灯しない /
Green LED does not light up
黄色い LED が点滅、アラー
ム / ヘルスが存在する場合は
対応する出力信号に注意 /
Yellow LED flashes; if Health
is present then take note of
the corresponding output
signal; if Alarm is present
then take note of the
corresponding output signal
ライトオン
1
2
原因 /
Cause
無電圧、または電圧が限界値
以下 /
No voltage or voltage
below the limit values
電圧がきていない又は不安
定 /
Voltage interruptions
センサの異常 /
Sensor is faulty
センサの動作準備はまだ整
っているが、動作条件が最適
ではない / さらにヘルス出
力の場合: 電圧供給が中断さ
れている /
Sensor is still ready for
operation, but the operating
conditions are not ideal/
additionally with health
output: power supply
interrupted
69
故障診断
t = 1
t = 2
対策 /
Acción
電源を確認し、すべての電気
接続(ケーブルおよびプラグ
接続)を確認します /
Check the power supply,
check all electrical
connections (cables and
plug connections)
安定した電源電圧が供給さ
れていることを確認します /
Ensure there is a stable
power supply without
interruptions
電源に問題がなければ、セン
サを交換します /
If the power supply is OK,
replace the sensor
動作条件を確認します : 投光
光軸(投光スポット)が背景
に当たるようにします / 光
学面の洗浄 / 感度を再調整
する(感度調整ボリュー
ム) / 検出距離を点検し必要
に応じて調整する、グラフ F
参照。 / ヘルス出力の場合:
電圧供給の点検、全ての電気
接続 (ケーブルおよびコネク
タ接続) の点検を行う /
Check the operating
conditions: Fully align the
beam of light (light spot)
with the background. /
Clean the optical
surfaces . / Readjust the
sensitivity (potentiometer) /
Check sensing range and
adjust if necessary; see
graphic F. / With health
47

Publicidad

Tabla de contenido
loading

Tabla de contenido