Operating Instructions; Maintenance: Deflating - Cleaning - Folding - Storage - Sevylor ADVENTURE Manual De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
b) Mini double-lock valve(s) for inflating seats. See drawing on page 2: Open the valve (A). To begin inflation, open
external stopper and pull to extend out (B). Insert nozzle of inflation device into the extended valve and turn on or
begin pumping (C). To close valve: push in with inflation device until stopper has been depressed, sealing internal
stopper (D). Remove device and close external stopper. Valve should appear depressed into itself (E).
3. Inflate the kayak in the order of inflation as shown on the capacity plate printed on the kayak (see also figure # 1 –
numbering of the valves).
4. Max. air pressure: The correct pressure for this item is : 0.1 bar/1.5 PSI (= 100 mbar) ) for side chambers,
0.06 bar/0.9 PSI (= 60 mbar) for bottom chamber. Do not exceed it. Check the pressure using the pressure gauge
(**) supplied with your kayak. Overpressure: deflate until you reach the recommended pressure. Drop of pressure:
inflate again
slightly.
If you leave your product exposed to the hot sun check the pressure and deflate it slightly, otherwise the
material might be overstretched.
The ambient temperature affects the tube's internal pressure: a variation of 1°C causes a variation of the pressure in
the tube of +/- 4 mbar.
REMOVABLE FIN
Fitting of the fin is recommended whenever you use your kayak in deep water (lake, sea, etc.), where it helps keep the
kayak in a straight line. Fitting of the fin is not recommended for use in shallow water or white water. The fin would be
likely to damage the bottom of the kayak in shallow water and would reduce manoeuvrability in white water. The bow and
stern lines of the kayak have been designed to ensure good handling without the fin.
ADJUSTABLE INFLATABLE BUCKET SEATS
The bucket seat can be adjusted to meet your needs. Adjust the belt lengths using the buckles at each end. You can also
adjust the position of the seat by moving it in the raised area; the raised area and the lower part of the seat have hook-
and-loop strips for easy adjustment.
E
N

OPERATING INSTRUCTIONS

G
L
I
 BEWARE OF OFFSHORE WINDS AND EBB CURRENTS!
S
 Get informed on local regulations and hazards related to this sport and to water activities.
H
 Obtain information from the local authorities about the area where you plan to use your kayak, tides and currents.
 Before using the product, please check it carefully.
 A bad distribution of the load can destabilize the kayak and may result in a loss of control.
 Do not overestimate your strength, your endurance or your abilities.
 Never underestimate the forces of nature.
 Always wear a Personal Flotation Device approved by proper authorities.
 Do not exceed the authorized number of persons or weight.
 Avoid all contact between the buoyancy tubes and sharp objects or aggressive liquids (such as acid).
 This product is delivered with a carry bag. Keep it away from children. Danger of suffocation!
 Must not be towed by a boat or any other vehicle.
MAINTENANCE: DEFLATING – CLEANING - FOLDING – STORAGE
1. Remove oars/paddles and other accessories.
2. To deflate, unscrew the valve insert and open the valve(s) cap.
3. Mini double lock™ valve: For deflation, open external stopper and pull the valve to extend it out so that the air can
escape (see the figure on page 2 / F).
4. Clean and check the item as well as all the accessories after each use. Rinse it thoroughly making sure to remove any
residues of salt if used in salt water. Use a mild soapy solution, do not use detergents or any type of silicone-based
products. Make sure that the product is completely dry before putting it away.
5. You can fold your boat to carry it as a backpack. Refer to the illustrations on page 3 of this manual.
Folding your boat: BPS Backpack System
TM
a. Adventure
unhook the 2 fastening points.
b. Fully unfold the "BPS" starps, placing the grey straps under the black straps.
c. Fold the sides of the boat inwards. You can place the deflated seats on the back of the folded boat .
Plus model : Detach the aft spray skirt retention cords, revealing the grey and black straps, then
WARNING!
CAUTION!
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Adventure plus

Tabla de contenido