Fermax Halo Manual De Instrucciones página 59

Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft
Option 1: From Panel + Monitor
1. With the monitor connected, press the programming button «PROG
seconds (to access this, you must lift up the front cover). A confirmation tone will be
emitted.
2. Press the call-to-residence button. A different confirmation tone will once again sound,
and the programmed number will be shown on the DISPLAY (for 2 seconds).
Option 2: From the Monitor
1. Go into configuration mode: Press the button
once each second and a confirmation tone is emitted.
2. Put the monitor into programming mode: With the monitor connected, press the
programming button «PROG
the front cover). A confirmation tone will be emitted.
The first thing the monitor then does is indicate the number of the current monitor on
the DISPLAY. If it is not programmed, it will show the following: - - -
3. Programme the call number: Each time the button corresponding to hundredths,
tenths or units is pressed, the figure goes up by one and is shown on the DISPLAY.
Hundredths: Press the button
Tenths: Press the button
Units: Press the button
4. Exit programming mode: Press the programming button « PROG
seconds, or wait 30 seconds before pressing any button.
When you exit programming mode, the number indicated is stored. If it is correct (between 1
and 199), a confirmation tone is emitted; if it is not correct, an error tone is emitted, and the
«Err» message is shown on the DISPLAY.
» for 1 second (to access this, you must lift up
(SW2)
Once you reach 9, if you press again, it
returns to 0 and a low error tone is
(SW3)
emitted. The next time you press, it will
go to 1.
(SW4)
for two seconds. The LED blinks
» for 2
» for 2
Pag 19