Fermax Halo Manual De Instrucciones página 78

Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft
OPERATION- User Access Control
Open door
Open the door with a user card
(previously programmed).
27 ºC 10:54
To call press
27 ºC 10:54
To call press
Programming
It is possible to add and delete user cards. To access these options, you must "Enter
Programming".
Enter Programming mode
1. Press the keys marked with a dot (except the bell key)
sequentially from left to right. The first key once, the second
twice, the third 3 times and the fourth 4 times. If entered
correctly, a long tone confirmation will be heard at the final
press, except in the first.
Key 1-> press 1 time
Key 3-> press 3 times
2. Key in the
User Programming Code,
it has been changed).
-Entering Data:
Upward Arrow Key: To enter digits/symbols, shown in
ascending order: 1, 2, 3, 4 ... etc.
Downward Arrow Key: To enter digits/symbols, shown in
descending order: #, *, 9, 8 ... etc.
Confirmation key: Press after entering each digit/symbol.
Cancel key or return to previous digit or symbol.
Pag 38
27 ºC 10:54
DOOR OPENED
27 ºC 10:54
Note:
door will not open and a «CODE NOT VALID» message is
WRONG CODE
shown on the screen, while an error tone is heard (bop
bop).
+ +
Beep beep beep beep
Door open, please
close after entering
If the card is not authorised in the system, the
Key 2-> press 2 times
+
Beep beep beep beep
Key 4-> press 4 times
which by default is
27 ºC
To call press
+ + +
Beep beep beep beep
19025.
(Consult your installer in case
27 ºC
Programmer code:
_ _ _ _ _
10:54
10:54