Parameters Reset - Fermax Halo Manual De Instrucciones

Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft

Parameters Reset

It is possible that at some point you may want to retrieve the original configuration of
the reader. To make this task easier, a Reset Code has been included for the reset of:
- User Programming Code
- Administrator (Installer) Code
- Master Proximity Card.
Note:
Reset is an irreversible operation.
Once reset is complete, the User and Administrator codes return to their default
configuration and the Master Card is deleted.
The steps for resetting the parameters are:
1. Disconnect the panel power supply.
2. Keep the bell
heard.
3. Release the bell key and "Programmer Code: 00000" is shown on the screen.
4. Enter the Reset Code: 11090. You have 1 minute to introduce this code.
2
4
27 ºC 10:54
Programmer code:
1 1 _ _ _
key pressed and supply power to the panel and a beep is
27 ºC
Programmer code:
1 1 0 9 0
. . . .
27 ºC 10:54
To call press
Beeeeeeeep!!!
10:54 27 ºC
Reset Codes
1
3
27 ºC
Programmer code:
0 0 0 0 0
10:54
The panel resets the power
supply and the default codes
are now updated.
10:54
Pag 31