Angelcare AC117 Manual De Usuario página 18

LOSS OF CONNECTIVITY BETWEEN THE NURSERY UNIT AND THE WIRELESS SENSOR PAD
• In the case of loss of connectivity, the first step is to bring the Sensor Pad and Nursery Unit closer together
and make sure that both units are ON to restore the connection. If there is still no connection after the above
has been done, then and only then should the re-connection procedure below be done. Make sure that no
other wireless Sensor Pad is in the same room during the reconnection procedure.
3
• The reconnection should be completed within 30 seconds.
• The reconnection is successful when Nursery Unit sounds a confirmation tone.
NOTE:
During the reconnection procedure make sure that no other wireless Sensor Pad is in the same room.
FALSE ALARMS
• Turn OFF the Nursery Unit.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or slat base, place a
hardboard between the crib base and the Sensor Pad measuring at least 1/4'' (6 mm) thick and should have
minimum dimensions of 13'' x 13'' (33 x 33 cm).
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to be
adjusted, refer to Step 5.4.
18
The Parent Unit will display H1-H2 icon during the reconnection
procedure. The reconnection is successful if the Parent unit
shows the regular screen view.
1) Turn both Units OFF.
2) Remove and replace the battery from
the Sensor Pad.
3) Turn the Nursery Unit ON by pressing
2 seconds on the Power ON/OFF button.
4
4) Press and hold the Pause button on the Nursery
Unit for 3 seconds.
Power Indication of the Nursery
Unit will turn green.
The Sensor Pad indicator
Light of the Nursery Unit will
blink blue.
BLUE