Forch F40 Manual Del Usuario página 38

1× coolant bottle
■
1× chip hook
■
1× Weldon drill chuck
■
1× taper drift MK3
■
1× B18 / MK3 drill chuck reduction
■
1× tappet large/small
■
1× operating manual
■
Safety information
When working with this machine, improper handling and/or poor maintenance can cause considerable
danger, which can lead to the destruction of the machine and to serious accidents with severe physical
damage. Please observe all the following safety instructions and contact our service team if you have
any questions. When drilling in vertical alignment, the magnetic drilling machine must be secured with
the securing strap supplied. The magnetic holding force is not maintained in the event of a power cut.
The drilled out core is automatically ejected by the guide pin. The guide pin may break if handled im-
properly. Only use undamaged connection cables and extension cables and check regularly for damage.
There is the risk of an electric shock. Mains voltage and voltage specifications on the device must match.
When working with this device wear the following safety equipment: Safety goggles, sturdy shoes,
ear protection, hairnet (for long hair), apron and helmet if necessary. The installation surface for the mag-
netic base must be flat, clean and stainless. Remove layers of paint and filler. Do not carry out electric
welding work on the work piece on which the metal core drilling machine is used. Before all work,
install the coolant system to assist cooling.
Persons with a pacemaker or other medical apparatus may only use this machine with the prior consent
of a doctor!
Never reach into, or touch rotating parts! When the motor is running keep hands and fingers away from
the work area, injury risk!
CAUTION: Make sure to read before using the machine.
The magnetic drilling machine may only be used for the intended use.
Use as a solenoid is dangerous and inadmissible in any case. Misuse entails danger for man and ma-
chine.
Structure
The magnetic drilling units consist of the device components drill stand and drill drive. The components are
permanently connected to each other and cannot be operated individually or separately. The drill stand is
made of cast aluminium and contains all important electrical and mechanical controls. The magnetic
drilling units are equipped with high-performance electromagnets, as well as a self-starting lock for the
drill drive. The magnetic drilling units comply with protection class I with protective conductor according
to IEC 745. The drilling drives, which were developed in compliance with DIN VDE 0740 and IEC 745-1,
are radio interference suppressed according to EN 55014 and EN 61000 and designed for continuous
operation. The sound pressure level at the workplace may exceed 85 dB (A). In this case noise protection
measures are required for the operators.
The noise emission values of our magnetic drilling unit are based on DIN 45649 part 2, DIN 45635 Part
21 and DIN EN 27574 (ISO 7574). Magnetic drilling units with fine positioning - only on suitably equipped
machines - allow precise setting of the drilling tool in any position within the adjustment range.