Worx WR130E Manual Del Propietário página 19

Your Landroid is inside its working
area and the boundary wire is
connected, but
'– E1 –' is displayed.
The charging time is far more than
the rated charging time.
The mower does not charge.
Landroid is starting to have shorter
run-times between charges.
Landroid is not operating at the
correct time.
Landroid cannot correctly dock
with the charging base.
The green light on the charging
base turns on before charging is
complete.
Landroid wheels skid or repeatedly
slip.
Landroid runs outside the boundary
wire.
Landroid does not mow an area
within a
boundary wire zone.
Landroid reverses or rotates errati-
cally near the boundary wire.
Landroid slips out of its working
area going down a hill.
The boundary wire ends are clamped
incorrectly.
Poor connection caused by debris on
the charging strip.
The charging protection program is
activated due to high temperature.
There is no power.
Something is clogging in the blade disc
creating friction and increasing power
consumption.
Landroid is shaking heavily because the
blade disc is unbalanced.
The battery may be exhausted or old.
The working time is up
The clock is not set to the correct time.
Programmed cutting times for Landroid
are not correct.
the percentage of weekly operating time
set through APP has changed.
Environmental influences.
Poor connection caused by debris on
the charging strip.
the charging base is overheating or
overcooling
Foreign obstacles, such as twigs and
branches may be lodged under
Landroid.
The lawn is too wet.
The boundary wire of another Landroid
or robotic mower is positioned too
closely.
In wet conditions, the boundary wire
electric signal may leak where the wire
has been joined or repaired incorrectly.
There is boundary wire electric signal
leakage due to broken insulation.
Low grip of Landroid drive wheels.
Reverse the boundary wire ends and reconnect
to the charging station.
Clean the contact pins located on the charging
base and the charging strip on Landroid using
a cloth.
Place the charging base in a shady area or wait
until the temperature has cooled down.
Check the power cord is connected properly to
the charger and the charger is connected to a
suitable power supply.
Make sure both the charging strips on the
mower touch the centre of the
contact strips on the charging base.
Take off the blade disc and clean it. Maybe the
grass is too high and too thick.
Check the blade disc and blades,
remove debris and foreign objects from the
blades and blade disc.
Replace the blades with a new set.
Replace battery.
reset the working time
Set the clock to the correct time.
Change the time settings for the mower to start
and stop.
set the correct percentage through APP.
Restart Landroid.
Clean the contact pins located on the charging
base and the charging strip on Landroid using
a cloth.
Place the charging base in a shady area or wait
until it reaches the normal temperature
Remove foreign objects from underside of
Landroid.
Wait until lawn has dried.
Ensure at least 1m clearance is provided in
between your boundary wire and that of your
neighbor.
Check boundary wire joints. Insulate to provide
a fully waterproof connection.
Repair damaged boundary wire
with the wire connectors supplied.
Please check the wheels are clean and free of
mud in order to have the
maximum grip possible.
EN
19