Environmental Protection - Worx WR130E Manual Del Propietário

Landroid operative system crashes
when charging or on standby.
Landroid shuts off when docking in
the charging base.
Landroid stops in the working area.
Landroid flips over.
Landroid fails to connect to the
internet.

Environmental protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
20
Software or display fault.
Landroid fails to charge due to over
temperature protection and is powered
off.
Poor connection.
There is an obstacle in the working area. Remove the obstacle from Landroid's working
The cutting height is set too low for the
length of the grass or the grass is too
dense.
The extended boundary wire should not
exceed 350m or it may cause signal
problem.
The distance between the center of
the lawn and the boundary wire should
not exceed 25m or it may cause signal
attenuation.
There is an inclined obstacle on the
lawn.
Please check your router has the correct
settings.
Please check whether the router is
disconnected or WIFI SSID is changed
Restart Landroid.
Place the charging base in a shady area or wait
until the temperature has cooled down.
Check the LED light on the charging base.
Check the connection between the
contact pins located on the charging base and
the charging strip.
area.
Raise the cutting height and then
gradually lower.
Reduce the lenght of the boundary wire.
Reduce the distance between the
center of the lawn and the boundary wire
perimeter within 25m.
Exclude the obstacle from Landroid's working
area.
Make sure your router is 2.4GHz. If your router
has two settings, please enable the 2.4GHz
band.
Make sure your router is set to 802.11 mode
and wireless setting is b/g/n mixed.
Make sure your router has the SSID Broadcast
function enabled when you connect the
machine with the app.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to
connect Landroid to the new network.
If you have a "Fritz!box" router, please make
sure activate "Allow communication between
devices in same network" in the settings.
Make sure the router is connected and WIFI
SSID is correct
EN