Blood Pressure Q&A; Key To Display Icons - Citizen CH-456 Manual De Instrucciones

BLOOD PRESSURE Q&A
Q
Why is the blood pressure measured at home different from that measured by the
physician or at a hospital?
A
Your blood pressure may vary due to exercise, the ambient temperature or your mental
state. When you have a physician or nurse measure your blood pressure, the pressure
value is likely to be 10 to 20 mmHg higher than usual due to anxiety and/or stress.
Knowing what affects your blood pressure helps you to better monitor your health.
Q
Why does the blood pressure obtained vary with measurement?
A
Our blood pressure is adjusted by automatic nerve function. Blood pressure differs
with every heart beat. We are likely to think that our blood pressure is constant, but
it varies if you take measurements in repetition. Blood pressure is susceptible to the
time of day, such as morning and afternoon, season and atmospheric temperature.
In addition, blood pressure is easily affected by mental stress or emotional ups and
downs. It tends to increase when you feel tension or decrease when you are relaxed.
Q
What is the benefit of measuring my blood pressure at home?
A
Blood pressure measurements taken at home give reliable data as they can be taken
when you are in a stable and relaxed condition. Physicians place considerable importance
on blood pressure measurements taken at home. You should measure your blood
pressure at the same time each day and record the variations in your blood pressure.
Always consult your physician for an interpretation of your blood pressure
readings and to determine the proper treatment.

KEY TO DISPLAY ICONS

DISPLAY MARK
or
CONDITION/CAUSE
Appears when the cuff is
attached too loose.
Appears when the cuff
is not attached correctly
and the pulse cannot be
detected.
Appears when the
pressure is 300mmHg or
higher.
The pressure is 281 mmHg
or higher.
Appears when the
batteries have run out.
- Eng 16 -
CORRECTIVE ACTION
Attach the cuff properly and
measure again.
( See page 10 "ATTACHING
THE CUFF")
If the pressure does not
automatically decline during
measurement, immediately press
the " START/STOP" switch
and turn the unit off. Take the
measurement again.
Replace the batteries. (
See page 7 "REMOVING THE
BATTERIES".)