Time Adjustment - Citizen CH-456 Manual De Instrucciones

TIME ADJUSTMENT

Setting the clock enables measurements to be accurately recorded.
The monitor can record the date and time of measurement as well as the measurement results.
Be sure to set the clock after inserting the batteries. Set the date first and then the time.
* When you install the batteries for the first time, the monitor will display the
clock setting screen. You do not need to perform step 1. Proceed to step 2.
If you set the clock and change its setting, start from step 1.
1
Press and hold the
The "year" indicator blinks.
2
Press the
Press Adjust switch to increase the number by one.
(The year can be adjusted in the range of 2015-2044.)
Press Date/Time Set switch to confirm the setting.
The "year" is set and the "month" indicator blinks.
* You can fast-forward the numbers in display by
pressing and holding
3
Press the
Press Adjust switch to increase the number by one.
Press Date/Time Set switch to confirm the setting.
The "month" is set and the "day" indicator blinks.
4
Press the
Press Adjust switch to increase the number by one.
Press Date/Time Set switch to confirm the setting.
The "day" is set and the "hour" indicator blinks.
5
Press the
Press Adjust switch to increase the number by one.
Press Date/Time Set switch to confirm the setting.
The "hour" is set and the "minutes" indicator blinks.
6
Press the
Press Adjust switch to increase the number by one.
Press Date/Time Set switch with the time signal on the
radio, etc. to confirm the setting.
The "minutes" are set and "12" (12-hour format) blinks.
7
Press the
The setting switches between 12-hour format (12H) and 24-
hour format (24H) each time
Press Date/Time Set switch to confirm the setting (12H or 24H).
When clock adjustment is completed, the set date and time appear briefly and
then the display turns off.
Date/Time Set switch for approximately two seconds.
Adjust switch to adjust the "year".
Adjust switch.
Adjust switch to adjust the "month".
Adjust switch to adjust the "day".
Adjust switch to adjust the "hour".
Adjust switch to adjust the "minutes".
Adjust switch to adjust the "time format".
Adjust switch is pressed.
- Eng 9 -