Crevice nozzle
For edges, joints, heaters and hard to
reach locations.
Operation
Always work with an inserted car-
tridge filter - during wet as well as
dry vacuum cleaning!
Before Startup
Illustration
Mount loose parts delivered with appli-
ance prior to start-up.
Illustration
Recommendation: To vacuum fine
dust, use the filter bag.
Start up
Illustration
Connect accessories.
Illustration
Plug in the main plug.
Illustration
Turn on the machine.
Dry vacuum cleaning
Work only with a dry cartridge filter!
Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
Recommendation: To vacuum fine
dust, use the filter bag.
The filling level of the filter bag depends
on the dirt that is sucked in.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
Wet vacuum cleaning
Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Blowing function
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
Connect the suction hose to the blower
connection, this will activate the blower
function.
Interrupting operation
Turn off the appliance.
Illustration
Hook the floor nozzle into the parking
position.
Finish operation
Turn off the appliance and disconnect
the mains plug.
Empty the container
Illustration
Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
Storing the appliance
Illustration
Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.
– 8
EN
13