Intended Use; Assembly And Operation - Worx WX128 Manual Original

personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book crefully.

INTENDED USE

The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
EN EN
Removing the battery pack
14 14
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Always ensure the bit is secure before
starting the tool. Damage to the Chuck or a loose bit may
cause possible personal injury.
Removing the bits
Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate
for long periods at low speed
FIGURE
because excess heat will be produced
internally.
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig.
C1,C2,C3
See Fig. D
See Fig. E
See Fig. F