Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
that matches the amperage described on the
fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. To prevent this, open the
front panel by pressing (OPEN), then detach it
and clean the connectors with a cotton swab
dipped in alcohol. Do not apply too much
force. Otherwise, the connectors may be
damaged.
Main unit
Back of the front panel
Notes
• For safety, before cleaning the connectors, turn off the
engine and remove the key from the ignition switch.
• Never touch the connectors directory with your fingers
or any metal device.
Dismounting the unit
Fuse (10 A)
Press the clip inside the front cover with
a thin screwdriver, and lever the front
cover free.
Release key
(supplied)
µ
µ
µ
µ
EN
21