If you cannot tune in a preset
station
Press either side of (SEEK/AMS)
momentarily to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Press either side of (SEEK/AMS)
repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SHIFT), then press (3) (PLAY MODE) repeatedly until
"Local" (local seek mode) appears. Then press (4) (n) to
select "Local on." Press (SHIFT).
Only the stations with relatively strong signals will be
tuned in.
Tip
If you know the frequency of the station you want to listen
to, press and hold down either side of (SEEK/AMS) for a
few seconds until the desired frequency appears (manual
tuning).
If FM stereo reception is poor
EN
— Monaural Mode
1
Press (SHIFT), then press (3) (PLAY
MODE) repeatedly until "Mono" appears.
2
Press (4) (n) repeatedly until
"Mono on" appears.
The sound improves, but becomes
monaural ("ST" disappears).
3
Press (SHIFT).
To go back to the normal mode, select "Mono
off" in step 2 above.
Changing the displayed item
Each time you press (DSPL), the item changes
as follows:
Station name ˜ Clock
8
RDS
Overview of the RDS
function
The Radio Data System (RDS) is a
broadcasting service that allows FM stations to
send additional digital information along with
the regular radio programme signal. Your car
stereo offers you a variety of services. Here are
just a few: re-tuning the same programme
automatically, listening to traffic
announcements and locating a station by
programme type.
Notes
• Depending on the country or region, not all of the RDS
functions are available.
• RDS may not work properly if the signal strength is
weak or if the station you are tuned to is not
transmitting RDS data.
Displaying the station
name
The name of the station currently received
lights up in the display.
Select an FM station.
When you tune in an FM station that
transmits RDS data, the station name
appears in the display.
F M 1
SUR EQ
BBC 1 FM
Note
The "*" indication means that an RDS station is being
received.
Changing the displayed item
Each time you press (DSPL), the item changes
as follows:
" Frequency
" Clock
Note
"NO Name" appears if the received station does not
transmit RDS data.
" Station name