Unpacking And Installation - Berkel B12A-SLC Manual Del Propietario - Operador

UNPACKING AND ASSEMBLY
•­ When­the­slicer­has­been­unpacked­and­removed­from­its­shipping­carton,­it­should­be­checked­
carefully­for­any­damage­that­may­have­occurred­during­shipment.­Do­not­plug­in­the­power­
cord­or­attempt­to­operate­the­slicer­prior­to­this­examination.
•­ Carefully­check­all­slicer­components­such­as­the­product­table,­pusher,­sharpener,­thickness­
control­knob,­etc.,­to­make­certain­they­move­freely­and­that­there­are­no­obstructions.­Turn­the­
thickness control knob as far right as possible. Lubricate the pusher slide bar (on the product
table)­and­the­square­and­round­table­support­rails­(underside­of­slicer)­with­Berkel­Food­
Machine Oil.
Use only USDA-authorized oil on this slicer. Non USDA-authorized oil may contaminate this slicer
and­cause­food­poisoning­and­personal­injury.­Berkel­Food­Machine­Oil­is­an­USDA-authorized­oil­
for­food­processing­equipment.­Berkel­Food­Machine­Oil­can­be­purchased­in­2­oz.­bottles­(Part­
#4675-0182),­16­oz.­bottles­(Part­#4675-0183)­or­gallons­(Part­#4675-0184).
1. Make­sure­that­the­ON/OFF­switch­is­on­the­"Off"­position­and­the­thickness­control­knob­is­
turned­as­far­to­the­right­as­possible.­This­positions­the­gauge­plate­so­the­knife­is­not­exposed­
during testing.
2. Plug the power cord into a grounded 120V AC electrical outlet.
3.­ Slide­the­product­table­back­and­forth­holding­on­to­the­Product­Table­Handle.­If­there­is­any­
rough­operation­or­obstruction,­shut­off,­unplug­power­cord­and­call­your­Berkel­servicer.
4.­ Turn­the­slicer­on­by­clicking­on­the­"On"­position­and­check­for­smooth­knife­rotation.­Turn­the­
slicer­OFF.
WHEN­MOVING­THE­PRODUCT­TABLE,­GRASP­ONLY­THE­PRODUCT­TABLE­HANDLE.
6 • Owner/Operator Manual BK45780 (07-21)

Unpacking and Installation

WARNING
Testing Prior To Operation
WARNING