Troubleshooting Guide; Care And Maintenance - Good Earth Lighting UC1046-WH1-12T51-G Guia De Inicio Rapido

Linking Instructions
With power disconnected each additional fixture (not included) should be mounted in the
same way as the first installed fixture. Make sure that the distance between fixtures does
not exceed the connector cord length of 18".
1
Fig. 1
2
3
Fig. 3
Bulb Replacement Instructions
Replace only with a linear fluorescent bulb: Bulb #F8T5 8 W (UC1046-WH1-12T51-G);
Bulb #F14T5 14 W (UC1046-WH1-22T51-G) . Do not replace with any other bulb wattage.
Turn fixture off/unplug and allow to cool before replacing bulb.
1
Fig. 1
2
Fig. 2
3
Install the replacement bulb into the sockets by aligning the contact pins of the bulb
with the slots in the sockets. Press the metal ends of the bulb into the sockets and roll
the bulb backwards until the contact pins engage into the sockets. Replace the
diffuser in the top lip. Push the grooved edge of the diffuser down into the bottom edge
until it locks in. Restore power to the fixture.
Hg

Troubleshooting Guide

Minor problems often can be fixed without the help of an electrician. Before doing any work
on the fixture, shut off power supply at the circuit breaker panel to avoid electrical shock.
r P l b o m e
Fixture doesn't light.
Fuse blows or circuit breaker
trips when light is turned on.

Care and Maintenance

Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner
and soft cloth. When cleaning the fixture, make sure the power is turned off.
Do not spray cleaner directly onto any part of the fixture or bulbs.
Replacement Parts List
Keep this guide handy for
ordering replacement parts.
Need Help?
In the event you are missing a part or have questions regarding installation
please visit our website at
call the Customer Care Center 1-800-291-8838,
8:30 a.m.-5 p.m., CST, Monday-Friday.
Using a flathead screwdriver, carefully pry off the plastic
cap that covers the power port on the fixture (Fig. 1).
NOTE: The linking cord is fitted with a distinct cord
Fig. 2
connector plug at each end and will only connect one way.
Try inserting one end of the linking cord into the power port,
if that fails try the other end of the linking cord (Fig. 2). DO
NOT try to force the plug into the port. When correctly
inserted the catch on the top of the cord connector plug will
click into the power port.
Link additional fixtures by following the linking instructions
outlined in steps 1 and 2 (Fig. 3). Once all fixtures have been
linked, insert the power cord connector plug into the power
port on the end of the last fixture and the grounded plug into
the outlet. NOTE: Each light can be individually operated by
the on/off switch located on each fixture.
Remove the diffuser by pulling back and up on the top
edge of the diffuser (Fig. 1).
Remove the bulb from the fixture by placing both
Fig. 3
thumbs on the metal ends of the bulb (Fig. 2). While
applying slight pressure on the metal ends, roll the bulb
forward until the contact pins on the ends of the bulb
disengage from the socket (Fig. 3). Pull the bulb straight
out from the socket and set aside.
Lamp contains Mercury. Dispose according to local,
state, or Federal laws. See: www.lamprecycle.org
C u a e s
Bulb is defective.
Power is off.
Bad connection.
Bad switch.
Discontinue use.
Hardware Kit
ZH-UC1046F00
www.goodearthlighting.com/support
- 4 -
o S t u l n o i
Replace bulb.
Check if power supply is on.
Check cords and/or wiring.
Test or replace switch.
Call customer service.
or