Renfert Top spin Manual De Instrucciones página 7

Top spin
EN
Nr. 1840 0000 / 1840 1000
ENGLISH
Introduction
This Quick Start Guide contains instructions on the operation of the product and relevant safety infor-
mation.
Detailed information on the product can be found in the operating instructions which are available for
download on our website at www.renfert.com.
Symbols
In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Laser
Do not look into the laser beam.
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
Other symbols are explained as they occur.
Safety
Proper Use
This device is a pinhole drilling unit designed to drill holes for the secure fixation of pins from various
different pin systems in dental arches made from plaster or epoxy resin (e.g. on a polyurethane basis).
The device may also be used to drill holes into acrylic base plates. It is exclusively for use in dental
laboratories or dental practices.
Improper Use
The device must not be used:
• for drilling into metal
• for milling
The product is not designed for use in the domestic environment.
Any application other than those described in these instructions for use is regarded as improper use.
The manufacturer is not liable for damage caused by incorrect or unauthorised use.
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this
product. If other spare parts or accessories are used, this could have a detrimental effect on the safety
of the device, increase the risk of serious injury and lead to damage to the environment or the device
itself.
- 1 -